Place the end of the straw into the opening of the lock where you normally insert your key.
Front door thumb latch sticking.
Repairs range from making minor latch adjustments to repositioning the door.
This will cause pressure that will make the latch stick while it is inside the door frame.
Lay the disassembled lock parts on layers of newspaper or paper towels.
Rinse it off and dry it good before installing it back into the door.
You can see where the cylinder entered the dead latch mechanism and pulled the latch back.
Tighten the hinge screws and then try adjusting the strike plate by loosening its screws and shifting it slightly.
Guide the straw as far in as you can to make sure you re hitting every part of the locking mechanism that might be sticking with the wd 40.
Once you have the door handle off you can now try to open the latch manually with either a large flathead screwdriver or pair of needle nose pliers.
On the kwikset locks this looks like two little teeth that the cylinder pushes back.
A coating of oil or silicone will also help.
Turn the knob to open the door and release the knob slowly.
The issue a door latch stuck due to a jamming latch will have no real variation between how the latch moves when it is pressed in or when the handle is turned both when the door is open and when it is shut.
Move to the edge of the door.
Take the door knob apart and lean the latch mechanism with clean water.
Slide the doorknob off the spindle pull out the lock mechanism and remove the latchbolt from its hole in the edge of the door.
Door lock doesn t latch properly when a door latch doesn t click into position it usually means the latch and the strike plate are out of alignment.
A sticking door latch might require some lubrication or it might be jamming against the strike plate on the door jamb.
Parts are unavailable as of january 22 2019 how to replace the mechanism on a weiser handleset when the thumb pushy downy thingie won t retract latch.
This is because the issue is not with the door and not even with the control the knob has over the stuck latch.
You should first test the door latch to ensure the latch is sticking inside the door and not due to a misaligned strike plate.
Insert the straw into the opening of the lock.
Insert the tip of your powdered graphite tube into the opening around the latch and inject a few.